Laser 5091 Code Reader User’s Guide
36
Laser 5091 Code Reader User’s Guide
37
7.2.4 Reset Factory Default
This menu will allow the users to restore the default configuration settings in the Configure Monitors
menu, and delete any customized settings. In this case, it will include all the available monitors for the
Spark IGN Required Monitors and Compression IGN Required Monitors. Still the Allowed INC
Monitors will be set to 1.
To reset factory default:
1. Use the UP/DOWN key to highlight Reset Factory Default from the menu and press the ENTER
key to confi
rm.
Figure7-10 Sample Configure Monitors Selection Screen
2. A message prompting to reset factory default displays. Answer Yes to confirm the request or
answer No to abort and return.
Figure7-11 Sample Reset Factory Default Screen
7.3 Unit of measure
Unit of measure opens a dialog box that allows you to choose between US customary or metric
units of measure.
To change the unit setup:
1. Scroll the UP/DOWN keys to highlight Unit of Measure from Setup menu and press the
ENTER key.
Figure 7-12 Sample Setup Screen
2. Press the UP/DOWN arrow key select an item and press the ENTER key to save and return.
Figure 7-13 Sample Unit Selection Screen
7.4 Key Beep Set
Key beep set opens a dialog box that allows you to turn on/off the built-in speaker for key
pressing.
To set the key beep:
1. Use the UP/DOWN key to highlight Key beep set from Setup menu and press the ENTER key.
Figure 7-14 Sample Setup Screen
To Next Page
Loading...
Need help?
General
