SELF-LEARNING PROCEDURE
To perform the self-learning procedure, you must have at least one
working remote control or electronic key then proceed in the
following manner:
1) Open the driver's side door, or put to the ground the light-blue
wire.
2) Switch on the key
3) Press button No. 1 of the working remote control and while
holding it, turn o the key, ff
then release the button of the remote control;
If you do not have a working remote control, use the electronic
key, placing it on the
LED socket with the ignition on and keeping it in contact turn off
the key.
4) The LED will flash 10 times will be on, status and then steadily
signaling the condition of self-learning.
Pairing wireless sensors/radicommands/electronic keys
Pag.21
1
5) From now:
- press button No. 1 of remote controls you have;all
- Place electronic keys you have on the receiver; all
- Open all windows, doors and lockers protected by magnetic sensor one at a time;
- Power on installed I sensors one at a time;all nfrared
a brief switching o of the LED confirms the successful encoding of each ff status
accessory
6) To finish the self-learning procedure, turn on the key.
WARNING
Sensors, remote controls and electronic keys not coded during the self-learning
procedure will be automatically deleted from the alarm memory.
You can enable a maximum of 20 wireless accessories and 4 electronic keys.
e.g. 2 remote controls + 18 sensors + 4 electronic keys
In the case of campers and motorhomes it is' possible to extend the protection adding to
the system wireless sensors:
- Magnetic sensors to monitor the opening of windows, doors and external lockers.
- Infrared sensors to monitor the interior of the living cell.
To Next Page
Loading...
