Depending on the characteristics of the vehicle and the customer's needs, it is possible to customize
the system by modifying certain functions.
Below are the programmable functions available.
1- ARM AND DISARM TONES
This function allows "arm/disarm" and "check" . to enable tones
2- VOLTAGE DROP SENSOR
This sensor generates an alarm when it detects a current absorbiment. Usefull to detech if is
switched on the internal courtesy light. (door open)
3- PULSE LOCKING SYSTEM TIME
Allow to choose the time of closure and opening pulse time between 0.8s or 3s.
4- COMFORT FUNCTION (only for specially equipped cars)
Enable the confort function ( function 19)need to set also
5 - INTERNAL RELAY PASSIVE ARMING
Allows automatic relay activation in the following cases
- 30 seconds after the engine is turned off
- 60 seconds after disarming the alarm system, without turning on the ignition.
Passive activation of the internal relay will be indicated by the fast flashing of the status LED.
In this situation, if you swich on the ignition will cause short and repeated beeps , and starting the
vehicle is inhibited. (relay contact OPEN)
To allow the vehicle to start, turn on the ignition and within 15 seconds turn o he system with remote ff t
control: the beeping ceases and the status LED goes out.
Beyond 15 seconds, the alarm will enabling all sensors and activate the siren sound.
In this condition it is possible to disarm the alarm with radio control or electronic key.
6- ACCIDENTAL ANTI DISARMING -
This allows the automatic alarm re-arm after 40sec. if it is accidentally disarmed and no one door /
bonnet /trunk is open. The function r teeactiva the power locking system but not the accessory
output. (white wire)
NOTE: the function is not available if the light-blue wire is connected to a internal light.
7- PASSIVE ARMING
This function allows the automatic without using the remote control 10 seconds after alarm re-arm
the last door is closed with the ignition key of he function does not activate the power locking f (t
system and the accessory output).
8- BUTTON FUNCTION 3 (only if function 18 is enable)
Allow to choose how to use Button 3 of remote control
- COURTESY LIGHTSSWITCHING : egative output on the wire activat n ionsWHITE BROWN-
for T20 seconds. his function is always available either with alarm armed or disarmed.
- BOOT OPENING : egative output on the wire activat secondn ions for 1 .WHITE-BROWN
This function is always available either with alarm armed or disarmed.
NOTE: if the boot opening is made in arm mode, the ultrasound sensor and the input doors/trunk
are inhibited for 60sec.
9- ()NEGATIVE DURING ALARM CONDITION OUTPUT require to active function 13
Allow to command the internal relay for an entire alarm cycle in two dif rent way:fe
- stable output, usefull to command an external syren
- blinking output, usefull to command the original horn.
Programmable functions
Pag.25
To Next Page
Loading...
