espresso coffee machines
LSI 022 - Rev. 00 - Ed. 12/2015
7
If it becomes necessary to replace the machine’s power supply cable, utilise only these types: CET ELETRIC H07rn-f 5
x 2.5 mm (400v) for 2/3 group versions, 5 x 4 mm (400v) for 4 group versions - CET ELETRIC SINGLE PHASE 3 x 2.5
mm (220v) 2 group versions, 3 x 4 mm (220v) for 3/4 group versions. replacing the cable must be carried out by qualified
personnel. The electrical safety of the appliance is fully achieved only after it has been correctly connected to an earthing
system as required by the laws in force.
The appliance must be supplied exclusively with cold drinking water. Maximum mains pressure (static pressure) must not
be higher than 0.6 Mpa.
If in doubt, concerning the above mentioned requirements (about the system previously installed by the customer), please
have them checked by qualified staff.
The electrical safety of the appliance is fully achieved only after it has been correctly connected to an earthing system as
required by the laws in force.
Danger!
Danger!
Danger!
Installation must be carried out by qualified personnel according to current laws and to the manufacturer’s instructions.
Incorrect installation may cause damage to people, animals or property for which the manufacturer cannot be held liable.
Attention!
Danger!
To Next Page
Loading...
