Perform this procedure to program other doses, using the filter holder for 1 cup (12, p. 2) or 2 cups (10, p. 3), depending
on the dose to be programmed.
!
Note!
To exit programming, press the continuous dispensing button for 5 seconds or wait 1 minute to exit automatically.
5.1
COFFEE DOSAGE PROGRAMMING (only EK)
Hold down the continuous
dispensing button on the first button
from the right, for about 5 seconds,
the two LEDs of the pressed
button start flashing.
Within 30 seconds place a
filter holder, containing a dose of
ground coffee, to the group and place
a cup under the corresponding group.
Press the button a 1 short coffee,
once the required dose of coffee is
reached, press the same button
again to stop.
Once the dose is set, the corresponding symbol will turn off, indicating that programming is complete. Repeat
the above procedure for the other buttons.
Note.
To Next Page
Loading...
