Lastec 425HD - Tires & Wheels; General

425HD-MD INITIAL SETUP
Tires & Wheels
425HD-MD INITIAL SETUP 425HD-MD/masterdoc101602 3-21
3
3.26 Tires & Wheels
All tires are foam filled with the exception of the rear drive tires.
Check the air pressure in the rear drive tires. Maintain an air pressure amount of 10psi.
Verify proper function of all mower deck gauge wheels. The wheels should turn freely
without excessive side-to-side motion, and be free of debris. Clean, adjust, replace, and
grease as necessary.
Check that each wheel swivels freely in the shaft pivot collar, and the bushings are in
good condition. If any wheel does not swivel freely, clean and grease the shaft collar
assembly. Replace the bushings if necessary.
3.27 General
Verify that all warning decals are in place, visible and legible.
Verify that all covers and safety devices are properly installed and secure.
Check that the discharge chute is clear of debris, properly mounted & in good condition.
Inspect entire Articulator for loose or entangled parts, debris, obstructions, neglected
tools, or any other possible safety hazards, equipment hazards or projectile hazards.