Latronics PVE1200 - Installation; Declaration of Conformity; Before Installation

DECLARATIONOFCONFORMITY
Manufacturer:
LatronicSunpowerPtyLtd
105GrigorStWest
MoffatBeachIndustrialPark
CaloundraQueensland4551
Australia
DeclarethatthePVEdgegridconnectedInverterModelNo.PVE1200and
PVE2500conformtotherequirementsoffollowingstandards
EN61000-6-1
EN61000-6-3
EN55014
AS1044
EN60335-1
AS3100
AS4777
AndthereforeconformtotheregulationsoftheECdirectives
Directive2004/108/CE(EMCdirective),Directive2006/95/CE(lowVoltage
Directive)
DatethatCEmarkingwasfirstaffixed2007
AlsoconformstotheregulationsofC-tickmarkforAustralianemissionstandards
AustralianSafetyCertificateapprovalnumberCS06713V
Allproductsaremanufacturedwithfulltraceabilityinaccordancewiththe
QualitySystemRequirementsofAS/NZSISO9002
Signed
WilliamPettit
ElectronicEngineer
7 Feb2009
th
PhotovoltaicCells
Mains
PVEdge
INSTALLATION
BEFOREINSTALLATION
!
!
GridInteractiveSolarSystemshavebecomeincreasinglypopularinrecent
years. Thesesystemsdonotnecessarilyrequirebatteriesforstorageand
thereforecanhaveaverysimpleconfiguration.
EnsuretheInverterhasnotbeendamagedintransit.
Theunitmustbeplacedinawellventilatedandprotectedarea,notexposed
totheopenenvironment,andfreefromcontaminates(i.e.exhaustgases,
seaair,dustetc.).
ThePVEdgeisdesignedforindoorinstallationinasuitablelocationwhere
ambienttemperaturewillnotexceedratedvalues.
IfthePVEdgeistobeinstalledoutdoors,pleaseusetheLatronicsOutdoor
Enclosure(Partno:OE)
Itisimportantthatallwiringintheinstallationcomplieswiththerelevant
standardssuchas AS4777and AS3000.
!
!
!
!
Anyworkcarriedoutistobepreformedby
QualifiedandLicensedpersonnel.
TheInvertercanbemountedhorizontalontableorfloor. TheInvertercan
alsobemountedonawall,takingnoteofthestickerbeingthecorrect
orientation.
2
19