Starting up
05.08.99
YAEE0012
15
−
The display for LEVEL (low-level) appears.
−
The fault triangle is flashing
−
Press the key. If necessary repeat several times.
−
Also press the key if the unit had switched off under a fault
condition.
6.3 Setpoint selection
or
−
Shortly press one of these keys
!
adjusted setpoint
appears for approx. 4 s.
−
°C is flashing, in contrast to the actual value.
−
During the 4 s. start to set the required setpoint using the
keys.
−
Speeding the setting process by:
a) continuous pressing the keys or
b) pressing one key (holding it down) and shortly pressing
the other key.
−
Briefly releasing (1 s) the key (s) and again pressing one of
the keys moves the cursor one place to the right.
−
Display flashes 4 s
!
the new value is accepted
automatically, or
−
Value is entered immediately with this key.
☞
−
For safety reasons the setpoint can only be adjusted up to 2 °C above the upper limit of
the operating temperature range of the particular unit type
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
