To Next PageTo Next Page
Need help?Do you have a question about the LAUER PCS 091 and is the answer not in the manual?
General| Display Type | TFT |
|---|---|
| Protection Class (Front) | IP65 |
| Input Voltage | 24 VDC |
| Interfaces | Ethernet, RS232, RS485, USB |
| Weight | 1.5 kg |
Details on supported PLC systems within the manuals.
Information regarding the interfacing of PLC systems.
Configuration and usage details for the Lauer driver.
Specifics and configuration for the AEG120DR driver.
Details and configuration for the MODBUSPS driver.
Information and configuration for the AEG250PX driver.
Configuration of board settings and baud rate.
Overview of the KOS handling software functionality.
Detailed parameterization for function block FB 200.
Steps for implementing the handling function block.
Procedures for integrating the program.
Program listing for the Restart-PB section.
Program listing related to communication loss.
Example program listing for parameterization.
Details on programming cable connections between UNIT and KOS.
Guidelines for screening communication cables.
Wiring diagram for the PCS 733 programming cable.
Details on the PCS 778 adapter cable for communication.
Flow and timing of data transfer sequences.
Initial setup and assumptions for commissioning.
Steps to load the AEG 120 DR driver into the PCS.
Procedures for connecting PCS to the programmable controller.
Common faults and solutions during commissioning.
Guidelines for connecting PCS to a PLC.
Comparison of synchronous and asynchronous communication modes.
Defining the common data area for PCS and controller.
Analysis of PCS to PLC response times.
Detailed explanation of asynchronous communication.
Detailed explanation of synchronous communication.
Steps to establish synchronous communication.
Overview of the handling software components.
Initial setup and assumptions for commissioning.
Steps to load the MODBUSPS driver into the PCS.
Procedures for connecting PCS to the programmable controller.
Common faults and solutions during commissioning.
Guidelines for connecting PCS to a PLC.
Comparison of synchronous and asynchronous communication modes.
Defining the common data area for PCS and controller.
Analysis of PCS to PLC response times.
Detailed explanation of asynchronous communication.
Detailed explanation of synchronous communication.
Steps to establish synchronous communication.
Overview of the handling software components.
Initial setup and assumptions for commissioning.
Steps to load the AEG250PX driver into the PCS.
Driver variables for PCS midi systems.
Driver variables for PCS maxi systems.
Procedures for connecting PCS to the PLC.
Common faults and solutions for the driver.
Guidelines for connecting PCS to a PLC.
Overview of the AEG250PX expander block.
Configuration parameters for the expander block.
Details on the PB1 program block.
Details on the FB200 function block.
Details on the FB201 function block.
Details on the FB202 function block.
Details on the FB205 function block.
Details on the FB210 function block.
Details on the FB211 function block.
Details on the FB212 function block.
Details on the FB213 function block.
Steps to load the handling software.
Details on the PCS 778 adapter cable.
Guidelines for screening the adapter cable.
Wiring diagram for the PCS 733 programming cable.
Analysis of PCS to PLC effective response times.
Measures to improve data transfer speed.
Explanation of communication error messages.
Explanation of symbols and ideograms used in the manual.
Crucial safety guidelines for device operation.
Information on product quality and support services.
Contact details for sales and distribution.
Information on how to contact technical support.
