LAUNCH KES-200 Cylinder Analysis
G-5
Fig.7-06
Press [►] [◄] keys to select the number of
cylinders of the tested vehicle, or enter the
number manually.
If the vehicle has an engine with more than five
cylinders, e.g. 6 cylinders, the number of
cylinders should be inputted. The screen will
display the interface as shown in Fig.7-07 after
inputting the number and pressing [ENTER] key.
Fig.7-07
Manually input the firing order and press
[ENTER] key. The screen will display as shown
in Fig.7-08.
Fig.7-08
Note:
Make sure to input the firing order correctly.
If a wrong firing order is inputted, the screen
will display error information. For example, if
mistake is made as shown in Fig.7-09 (two
“1”s are inputted), the screen will prompt
error information as shown in Fig.7-10 after
pressing [ENTER] key.
Fig.7-09
Fig.7-10
2 or 3 seconds later, the system enters the
power balance test function, as shown in
To Next Page
Loading...
