Launch KES-200 - Page 53

LAUNCH KES-200 Cylinder Analysis
G-14
Fig.7-31
When the engine speed is stable, press
[ENTER] key, KES-200 will perform cylinder
efficiency test as shown in Fig.7-32.
Fig.7-32
Note:
♦ If the selected number of cylinders is
larger than 4, the screen will request
you to input firing order as shown in
Fig.7-33.
♦ Make sure to input the right firing order;
otherwise the test cannot be performed.
For example, if you input an error firing
order as shown in Fig.7-34, the screen
will display the error information as
shown in Fig.7-35.
Fig.7-33
Fig.7-34
Fig.7-35
Caution: if the cylinder disabling cable or the
main cable is disconnected while sampling, the
screen will display error information as shown in
Fig.7-36. In this case, you should exit the test,
reconnect the cable and then retry again.