Launch KES-200 - Page 59

LAUNCH KES-200 PC Link
H-4
Fig.7-52
Fig.7-53
Press [1] key to select [1. Display], the screen will
display the menu as shown in Fig.7-54.
Fig.7-54
User can make choice between [1.Bar Graph] and
[2.Peak Wave]. When pressing [▼] key to select [2.
Peak Wave], the screen will display the peak
waveform corresponding to the bar graph, as shown
in Fig.7-55.
Fig.7-55
Press [2] key to save data (it can be done on either
BAR GRAPH or PEAK WAVEFORM display), the
screen will display a menu, as shown in Fig.7-56.
Fig.7-56
Press [▼] [▲] keys to select recorded data, and then
press [ENTER] key to save the waveform. For
example, select “8. Waveform 8”, press [ENTER]
key, the waveform will be saved and the screen will
be displayed as shown in Fig.7-57.
Fig.7-57
User can press [3] key to view the saved waveform (it
can be done on either BAR GRAPH or PEAK
WAVEFORM). Refer to the section “View Tested
Waveforms” for detailed procedure.