26 American Dryer Corp. 112146-61
Program Location 07 (PL07)
Perm Press Temp
Location to be viewed/changed.
Press “Perm Press” key.
Display will read “PP°F,” “Perm Press”
temperature key status for 3-seconds
and then actual temperature programmed.
If no change, press “Perm Press” key
otherwise press “HI” or “LO” key
and then “Perm Press” key.
Temperature Decrease Temperature Increase
Summary: Perm Press Temp is programmable from a minimum of 100 ° F to a maximum of 190 ° F in ten-degree increments or
from a minimum of 38° C to a maximum of 88° C in five-degree increments.
PL07
PP°F
Perm Press
130F HI Temp
Perm Press
LO Temp
Refer to Programming
Instructions for instructions on
entering program locations.
(Wait 3-Seconds)
Automatically goes into PL08 Program without PL08 Display Mode
Continued on next page
To Next Page
Loading...
