34 American Dryer Corp. 112146-61
Location to be viewed/changed.
Press “Perm Press” key.
Display will read “GdLY,” guard delay
time for 3-seconds and then time
programmed. If no change, press “Perm
Press” key, otherwise press “HI” or
“LO” key and then “Perm Press” key.
Program Location 15 (PL15)
Anti-Wrinkle Timing
Summary: Guard delay time is programmable from 1 to 9 minutes. Guard on time is programmable from 1 to 99-seconds.
Time Increase
Time Decrease
Time IncreaseTime Decrease
PL15
GdLY
Perm Press
2 HI Temp
Perm Press
LO Temp
Refer to Programming
Instructions for instructions on
entering program locations.
(Wait 3-Seconds)
20
("Hold In" to Accelerate) ("Hold In" to Accelerate)
LO Temp HI Temp
Perm Press
PL16
Proceed to next location
to be changed
To exit program mode,
open program switch
("Hold In" to Accelerate) ("Hold In" to Accelerate)
Gont
(Wait 3-Seconds)
Display will read “Gont” anti-
wrinkle on time for 3-seconds and
then time programmed. If no
changes, press “Perm Press” key,
otherwise press “HI” or “LO” key
and then “Perm Press” key.
To Next Page
Loading...
