7
PREPARING THE MACHINE
Place a glass below the dispensing spout.
Press the LUNGO supply button and wait for
water to be supplied.
In case water is not supplied, repeat the cycle
several times (up to six times max.).
Empty the full tank by performing again the dis-
pensing cycles to end the rinsing procedure.
Empty the glass every time it reaches its maximum
capacity level, by temporarily interrupting the cycle.
STANDBY FUNCTION
To ensure the energy conservation the machine au-
tomatically passes to the stand-by mode after 30
minutes of not being used. The machine can be set
to the stand-by mode manually, first of the 30 min
-
utes’ time, by keeping both buttons pressed down for
at least 3 seconds. This mode is indicated by the
switching off of the buttons. The machine can be
reactivated by pressing the buttons again.
PREPARATION FOR COFFEE BREWING
The coffee machine features two positions for
preparing the coffee: espresso cup/mug or glass.
Place the cup or small cup under the coffee dis-
penser, if you wish to have traditional espresso cof-
fee
.
Remove the drop collecting tray to use a glass, if
you wish to have weak coffee.
To Next Page
Loading...
Need help?
General
