LAVAZZA CLASSY PRO - One of the six buttons is not working and the corresponding LED is OFF; TECHNICAL SPECIFICATIONS; COMMUNICATION MODULE; SPARE PARTS

35
EN
N° Problem encountered Possible causes Solution Result
18
One of the six buttons
is not working and the
corresponding LED is
OFF.
1 - Mechanical
blocking
1 - Try to power the
machine off by
removing the power
cord for 10 seconds
then reconnect it.
Power the machine
on again and check
for proper operation
of all buttons.
Ok: call solved.
Non-ok: go to step 2
2 - If the problem
persists, the machine
can still be used with
other buttons.
Ok: call solved.
Non-ok: machine
being serviced.
The BT LE module installed within this product operates at:
Max Power: < 3dBm
This device contains licence-exempt transmitter/receiver that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the
device.
To maintain FCC and ISED Canada compliance, a separation distance of 7,8in (20cm) must be maintained
between the user and the host product to comply with general / unrestricted RF exposure requirements
Contains FCC ID: 2AIWT-EFBTLE16
Contains IC: 21696-EFBTLE16 CAN ICES-3(B)/NMB-3(B)
COMMUNICATION MODULE
TECHNICAL SPECIFICATIONS
• Power supply: 120V / 60Hz
• Nominal power: 1450W
• Dimensions: Height Width Depth
13.7 in 7.9 in 16.1 in
35 cm 20 cm 41 cm
• Weight: 14.7 lb (6.7 kg).
• Water tank capacity: 60.8 US fl.oz (1.8 L ).
• Materials used for the body: thermoplastic.
• The machine has been developped to deliver 45
supplies (on average) per day.
As regards the faults not covered by the above table, or if the suggested actions do not remedy the
faults, contact the nearest Lavazza Authorized Service Centre.
TROUBLESHOOTING
SPARE PARTS
n. 10070879 Power cord