5.
Attached the supplied filter mounting bracket in the side compartment. Connection points
are molded into the side wall.
6.
Locate the water pipe that is looped inside the side compartment. Cut the loop.
YES
7.
Place the two ends of the pipe into the in and out push fits on the Lavit ECO3 filter. The
right side of loop is water in. Mount the filter into the mounting saddle.
8.
Before connecting the water supply to the dispenser, flush the water supply to waste, and if
the water is running clear, connect the water supply to the rear of the dispenser.
To Next Page
Loading...