9.
IN ANY KNOWN AREA WITH HIGH SEDIMENT WATER, A PRE
---
SEDIMENT FILTER
SHOULD BE INSTALLED BEFORE THE DISPENSER.
10.
Ensure that the Power Switch is in the OFF position (bottom in). Connect the power cord.
11.
Locate the CO
2
inlet pressure line inside the side compartment. Extend the line away from
the dispenser and trim the line using a tubing cutter so that the final length of the tube
extends to the inside of the door hinge.
12.
Connect the supplied CO
2
pressure regulator to the inlet tubing. Ensure that the regulator is
fully off by turning the knob fully counterclockwise.
13.
Wipe the bottle threads and screw the supplied 1.5-pound CO
2
cylinder onto the
regulator. DO NOT TURN THE GAS PRESSURE ON AT THIS POINT. Place the cylinder
in the side compartment ensuring the side door properly closes.
To Next Page
Loading...