Need help?Do you have a question about the LDG AT-200PROII and is the answer not in the manual?
Quick start guide for initial setup and operation.
Warning about exceeding power limits to prevent damage.
Crucial safety advice regarding antenna installation near power lines.
Description of the front panel buttons, LED bargraph scales, and indicator LEDs.
Recommendations for proper grounding and lightning arrestor installation for safety and performance.
Illustrates standard and ICOM radio installation configurations.
Explains how to operate the AT-200ProII using its front panel buttons.
Details how to access and set user-configurable options for the tuner.
Explains how to toggle between average and peak power display modes.
Covers changing the power meter scale selection.
Describes how to set the SWR threshold for automatic tuning cycles.
Explains how to select and manage antenna ports.
Details the function and indication of the Bypass LED.
Overview of how tuning cycles are initiated and their types.
Instructions for performing a memory tuning cycle.
Explains how to explicitly initiate a full tuning cycle.
Details the bypass function and its indicator LED.
How to manually adjust inductor and capacitor values for fine-tuning.
How to manually set the high/low impedance relay.
Guidance for using the AT-200ProII in a mobile environment.
Explanation of RF noise and tuner coverage for MARS/CAP operations.
Explains fundamental concepts of impedance in RF circuits.
Guidelines for proper tuning etiquette on ham radio bands.
Instructions for care, maintenance, and obtaining technical support.
Details the terms and conditions of the product's two-year transferable warranty.
Procedures for obtaining out-of-warranty service and returning the product for repair.
To Next Page
General
