Need help?Do you have a question about the LDG AT-897Plus and is the answer not in the manual?
General| Tuning Method | Automatic |
|---|---|
| Input Voltage | 13.8 V DC |
| Weight | 2.5 lbs |
| Current Consumption | 300 mA |
| SWR Range | 1:1 to 3:1 |
| Frequency Range | 1.8-54 MHz |
Instructions for initial setup and operation.
Information regarding power limitations and potential damage.
Specific guidance for tuning on the 6-meter band.
Critical safety advice regarding power lines and antenna installation.
Details the function of the Tune button.
Explains the purpose and indications of the Status LED.
Describes antenna and ground connection points.
Details the CAT interface ports for radio and PC.
Lists compatible Yaesu transceiver models.
Instructions for physically mounting the tuner to the radio.
Steps for connecting the tuner to the transceiver.
Final connection steps and PC control setup.
Describes how the tuner powers up with the transceiver.
Explains memory and full tuning cycles.
Table detailing the meaning of different Status LED indications.
Guidance for using the tuner in a mobile setup.
Introduction to impedance and its relevance in RF circuits.
Advice on proper tuning procedures to avoid interference.
Recommendations for cleaning and protecting the tuner.
Information on obtaining assistance, warranty, and service.
Instructions on how to return the product for repair.
Encouragement for users to provide feedback on the product.
To Next Page
