Need help?Do you have a question about the LDG Z-817 and is the answer not in the manual?
Quick start guide for initial operation without reading the entire manual.
Guidance on power limits to prevent damage to the tuner and transceiver.
Description and function of the Z-817's front panel controls and indicators.
Description of connectors and ports on the rear panel of the Z-817.
Detailed steps for installing the Z-817 with an FT-817 transceiver.
Instructions for installing the Z-817 with transceivers other than the FT-817.
Importance and methods of grounding the Z-817 for optimal performance and safety.
Explanation of the basic tuning process using the Tune button.
How the tuner uses stored settings for faster tuning cycles.
Process for performing a complete tune cycle from scratch.
How to switch the tuner between active and bypass modes.
Step-by-step guide to starting a memory tune cycle.
Procedure to force the tuner to find a better match than stored.
Explanation of LED indications for tuning status and error codes.
Guidelines for installing and using the Z-817 in a mobile environment.
Information on the tuner's coverage for MARS/CAP and other HF operations.
How to control the Z-817 and FT-817 using a PC via CAT interface.
Introduction to impedance and its role in RF circuits and antenna matching.
Explanation of impedance matching in the transmitter-antenna system.
Guidelines for responsible tuning practices to avoid interference.
Recommendations for cleaning and protecting the Z-817 unit.
Instructions for replacing the internal AA batteries.
Quick start guide for initial operation without reading the entire manual.
Guidance on power limits to prevent damage to the tuner and transceiver.
Description and function of the Z-817's front panel controls and indicators.
Description of connectors and ports on the rear panel of the Z-817.
Detailed steps for installing the Z-817 with an FT-817 transceiver.
Instructions for installing the Z-817 with transceivers other than the FT-817.
Importance and methods of grounding the Z-817 for optimal performance and safety.
Explanation of the basic tuning process using the Tune button.
How the tuner uses stored settings for faster tuning cycles.
Process for performing a complete tune cycle from scratch.
How to switch the tuner between active and bypass modes.
Step-by-step guide to starting a memory tune cycle.
Procedure to force the tuner to find a better match than stored.
Explanation of LED indications for tuning status and error codes.
Guidelines for installing and using the Z-817 in a mobile environment.
Information on the tuner's coverage for MARS/CAP and other HF operations.
How to control the Z-817 and FT-817 using a PC via CAT interface.
Introduction to impedance and its role in RF circuits and antenna matching.
Explanation of impedance matching in the transmitter-antenna system.
Guidelines for responsible tuning practices to avoid interference.
Recommendations for cleaning and protecting the Z-817 unit.
Instructions for replacing the internal AA batteries.
General| Type | Automatic Antenna Tuner |
|---|---|
| Tuning Method | Automatic |
| Latching Relays | Yes |
| Memories | 2000 |
| Connectors | SO-239 |
| SWR | 1.5:1 or less |
| Frequency Range | 1.8 - 54 MHz |
| Power Supply | 7-15 VDC |
To Next Page
