WWW.leaptonpv.com
1
Instructions during Installation
General Disclaimer
1.1
1 Safety Precaution
The information in this user manual is subject to change due to product updates or
other reasons. This guide cannot replace the product labels or the safety precautions
in the user manual unless otherwise specified. All descriptions in the manual are for
guidance only. Before installations, read through the quick installation guide. For
additional information, please see the user manual. All installations should be performed
by trained and knowledgeable technicians who are familiar with local standards and
safety regulations. Check the deliverables for correct model, complete contents, and
intact appearance. Contact after sales service if any damage is found or any component
is missing. Use insulating tools and wear personal protective equipment (PPE) when
operating the equipment to ensure personal safety. Wear anti-static gloves, cloths, and
wrist strips when touching electron devices to protect the equipment from damage.
Strictly follow the installation, operation, and configuration instructions in this guide and
relative user manual. The manufacturer shall not be liable for equipment damage or
personal injury if you do not follow the instructions. For more warranty details, please
visit: https://www.leaptonpv.com.
• The battery system is a high voltage system. High voltage exists when the equipment
is running. Please keep Power Off before any operations to avoid danger. Strictly follow
all safety precautions outlined in this manual and safety labels on the equipment during
the operation.
• The inverter used with the battery shall be approved by the battery manufacturer. The
approved list of batteries and the matched inverter can be obtained through the official
website.
• Do not disassemble, modify, or replace any part of the battery or the power control unit
without official authorization from the manufacturer, Otherwise, it will cause electrical
shock or damages to the equipment, which shall not be borne by the manufacturer. Do
not hit, pull, drag, squeeze or step on the equipment or put the battery into fire.
Otherwise, the battery will be exploded.
• Do not place the battery in a high temperature environment. Make sure that there is no
heat source near the battery and no direct sunlight. When the ambient temperature
exceeds 60℃. it will cause a fire.
• Do not use the battery or the power control unit if it is defective, broken, or damaged.
The damaged battery may leak electrolyte.
1.2 Safety Disclaimer
To Next Page
Loading...