Lear Siegler ADM 3A - Section Page

--_ LEAR SIEGLER, INC.
DATA PRODUCTS DIVISION
TABLE OF CONTENTS (cont'd)
SECTION PAGE
II INSTALLATION 2-1
2.1 GENERAL 2-1
2.2 SPECIAL SAFETY REQUIREMENTS 2-1
2.3 UNPACKING AND INITIAL INSPECTION " 2-1
2.4 SITE REQUIREMEN'I'S " 2-1
2.5 INITIAL PREPARATION " 2-2
2.5.1 Line Voltage Selection " 2-2
2.5.2 Set-Up Mode Preparation , 2-2
2.6 INTERFACE INFORMATION 2-2
2.6.1 'RS-232C Modem Port Interface 2-2
2.e.2 p...s 232C Ex~nsion Port Interface 2-2
2.7 INSTALLING THE ADM 3A 2-2
2.8 POVtTER TURN-ON 2-B
2.9 POWER TURN-OFF 2-10
2.10 CLEANING 2-10
2.11 INSPECTION 2-10
III OPERATION 3-1
3.0 PRELIMINARY NOTE 3-1
3.1 GENERAL 3-1
3.2 KEYBOARD OPERATIONS 3-1
3.3 SET-UP MODE OPERATIONS 3-1
3.3.1 Enter Set-Up Mode 3-1
3.3.2 Set Terminal Configuration Parameters 3-5
3.3.3 Exiting Set-Up Mode 3-5
3.3.4 Save Current Terminal Configuration Values ', 8-5
3.3.5 Enter Personality Mode " 3-10
3.3.6 Enter Answerback Programming Mode " 3-10
3.3.7 Program Mode " 3-11
3.3.8 Cancel Current Mode " 3-11
3.3.9 Restore Active Set-Up 3-11
3.3.10 Default Active Set-Up 3-11
3.3.11 Reset The ADM 3A 3-11
I: