- 14 -
ENGLISH
Instructions for magnet limit switches installation
Depending on the polarity
indicated by the letters "N" or
"S", the magnet activates the
opening or closing limit switch.
To determine in which direction
attach the magnet, scroll the
magnet close to the sensor (3-
4 cm above the gear). The
L s of the opening andED
closing limit switches located
on the unit will turn off
depending on the polarity of the
magnet. In this way you can
discriminate the correct
direction to attach the magnet.
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Once aware of the correct direction,
attach the magnet on metallic cam.its
Attach the metallic cam on the rack by
means of the grub screws. Put a drop of
threadlocker to stabilise.
To Next Page
Loading...
