15
EN
STAINLESS STEEL SURFACES ON SOME MODELS
Do not use the stainless steel cleaners for it will scratch the sur-
face. Use a hot, damp cloth with a mild detergent suitable for
stainless steel surfaces. Use a clean, hot, damp cloth to remove
soap. Dry with a dry, clean cloth.
If food soil remains, try a general kitchen cleaner. For hard-to-
clean soil, use a standard stainless steel cleaner. After cleaning,
use a stainless steel polish. Follow the product instructions for
cleaning the stainless steel surface.
OVEN LIGHT BULB
1.Bulb holder
2.Bulb
3.Glass cover
Note
The glass cover (on some models) should be removed only when
cold. Wearing latex gloves may oer a better grip.
Before replacing the bulb, disconnect electrical power to the
oven at the main fuse or circuit breaker panel. Let the bulb cool
completely before removing it. For your safety, do not touch a
hot bulb with a damp cloth. If you do, the bulb will break.
To remove:
Turn the glass cover counterclockwise1/4 turn until the tabs of
the glass cover clear the grooves of the socket. Remove the bulb.
To replace:
Put in a new 25-watt appliance bulb. Place the tabs of the glass
cover into the grooves of the socket. Turn the glass cover clock-
wise1/4 turn.
Note
• A 25-watt appliance bulb is smaller than a standard 25-watt
household bulb.
• Install and tighten the cover clockwise.
• Reconnect electrical power to the oven.
• For improved lighting inside the oven, clean the glass cover
frequently using a wet cloth. This should be done when the
oven is completely cool.
TROUBLESHOOTING
Food does not take or roast properly
Oven controls improperly set. See the Using the oven section.
Food does not broil properly
Shelf position is incorrect or the shelf
is not level.
See the Using the oven section.
Incorrect cookware or cookware of
improper size being used.
See the Using the oven section.
Improper shelf position being used. See the Broiling Guide.
Food being cooked in a hot pan.
Use the tray and grid that came with
your oven. Make sure it is cool.
Cookware not suited for broiling.
Use the tray and grid that came with
your oven.
In some areas the power (voltage) may
be low.
1) Preheat the broil element for 10
minutes.
2) Broil for the longest period of time
recommended in the Broiling Guide.
Clock and timer do not work
A fuse in your home may be blown or
the circuit breaker tripped.
Replace the fuse or reset the circuit
breaker.
Oven controls improperly set.
See the Using the clock and timer
section.
Oven light does not work
Light bulb is loose or defective. Tighten or replace the bulb.
Oven temperature too hot or too cool.
Oven thermostat needs adjustment. Call for service.
Oven will not work.
To Next Page
Loading...