MyWay+ User Manual p.44
12.0 Typical Set-Up Order
• Set the frame height
based on inside leg
measurement. See
section 9.12 ‘Overall
Height Adjustment’ for
full instructions. If the
user has xed exion
deformities of knees and/
or hips, measure the inside
leg directly from hip to
ankle, bypassing the knee,
to ensure that the user
is positioned to operate
MyWay+ within their
active range of lower limb
movement.
12.1 Height Adjustment
• Note that the ne height
adjustment does not lower
the user within the frame.
Therefore, initially position
the child in a slightly lower
position if ne tuning is
required.
• Note that when the user
is tilted forwards using the
prone angle adjustment,
the user loses height.
Therefore use the ne
height adjustment to
raise the child again if
the prone angle feature is
used. See section 9.10
‘Fine Height Adjustment’
for full instructions.
• See sections 10.2 ‘Donning
the harness in lying’ or
10.3 ‘Donning the harness
in supported standing’
• If the user has difculty
initiating stepping, tilt the
user forwards. Note the
loss of height as the prone
angle is adjusted. Use ne
height adjustment to raise
the child as required.
• See sections 9.10 ‘Fine
Height Adjustment’
and 9.11 ‘Prone Angle
Adjustment’ for full
instructions.
• Set direction as free or
uni-direction, as
appropriate for the user’s
steering ability. See section
9.7 ‘Direction lock feature’
for full instructions.
• Set resistance as free
or as required to ensure
optimum steering and
control of speed. See
section 9.9 ‘Resistance
feature’ for full
instructions.
• Set rear lock if the user
tends to roll backwards.
See section 9.8
‘Anti-roll back feature’
for full instructions.
• See section 10.4
‘Transferring the harness
to/out of the frame’
and 10.5 ‘Attaching the
harness to the frame’ for
full instructions.
• See section 9.15
‘Shoulder Height
Adjustment’ for
full instructions.
12.2 Harness preparation
and don
12.5 Prone angle adjustment
12.6 Castors
12.3 Transfer to Frame
12.4 Shoulder height
and supports
To Next Page
Loading...
