p20 Squiggles Stander - User Manual
10.6 KNEE SUPPORT
PADS
Attach the knee pads by clipping the
male buckle into the female buckle at
either side of the knee support, making
sure the opening of the front cover is
facing downwards as shown.
To adjust the tension lift the front panel,
adjust the straps to the required length
and then replace the panel.
10.7 PADDED SPINE CAP
Place the padded spine cap over the
spine of the standing support and place
the plastic loops around the adjustment
knobs.
10.8 CONTOURED
HEADREST CUSHION
To attach the headrest cushion, place the
cushion onto the head support plate,
then snap the central fastener and two
upper fasteners in place. Bring the lower
flap under the plate and snap the two
remaining fasteners in place.
To Next Page
Loading...
