Now, retrieve the sent ARB sent to your WaveStation as explained in
Main Save/Recall Operations (on page 57), by pressing the Save/Recall
Front Panel (on page 13) button, selecting Data using the FileType
operation button, selecting your waveform on the File display area on
the Browser, pressing the Recall control button.
The waveform you created using the PC Software is now shown in your
WaveStation.
PLEASE NOTE THE FOLLOWING:
A status message should then be shown on the bottom of the
Folder display area indicating the read completed successfully.
A scalar representation of the waveform data is sent. Adjust the
amplitude, frequency, and offset as desired.
To Next Page
Loading...