Lectra Alys 60 - 3.10 Replacement of the head;buffer reservoir unit

(MWQERXPMRKSJTVMRXMRKFPSGOTEVXW 
%% %P]WQEMRXIRERGIQERYEP
Attach the block with four screws. Tighten to a torque of 2 N.m.
Connect the linear encoder ribbon cable (Be careful of cable direction:
protected side of plug, in blue, visible from above).
6ITPEGIQIRXSJXLILIEHFYJJIVVIWIVZSMVYRMX
The “Removal of the electronics board” must be carried out.
Pass the head under the plotting block with caution.
raise it as shown below.
4PEGIXLIPMRIEVIRGSHIVVMFFSRGEFPI
FIX[IIRXLIFSEVHERHXLITPSXXMRK
FPSGOGEWMRK
4VMRXMRKLIEH
8LILIEHQSYRXMRKHMVIGXMSRGERFI
HIXIVQMRIHF]X[SGIRXIVMRKFPSGOW
-ROWYTTP]XYFI
;LIRQSYRXMRKFI
GEVIJYPRSXXSXSYGL
XLIWYVJEGISJXLI
TVMRXLIEH8LMWGER
WIVMSYWP]HEQEKIMX