Lectra Alys 60 - Replacing the paper feed encoder

0IJXWMHISJ4PSXXIVWIIRJVSQXLIFEGO 
%% %P]WQEMRXIRERGIQERYEP
Then tighten the motor fastening screws to a torque of 4 N.m.
Replace the earth braid and tighten lightly.
Plug in connector J to the electronics board.
 6ITPEGIQIRXSJGEVFSRW
Unplug the wire from the terminal if necessary.
Reposition a new carbon in the housing and re-screw the nut with care.
Reconnect the terminated wires if necessary.
 6ITPEGMRKXLITETIVJIIHIRGSHIV
!
$OZD\VVWDUWE\XQSOXJJLQJDOOWKHHOHFWULFDOFRQQHFWLRQVOLQNLQJWKH
SORWWHUWRWKHPDLQVDQGWRWKHFRQWUROOLQJ3&
Left side protection cover of the plotter removed
9RWGVI[XLIRYXERHTYPPSRXLIXIVQMREPXS
VIQSZIXLIGEVFSR
4ETIVJIIH
IRGSHIV
4ETIVJIIH
IRGSHIVGEFPI
4ETIVJIIH
IRGSHIVJEWXIRMRK
WGVI[