Lectra Alys 60 - 10.1 Cleaning ink stains on the plotter; 11. Handling

,ERHPMRK 
%% %P]WQEMRXIRERGIQERYEP
'PIERMRKMROWXEMRWSRXLITPSXXIV
!
7KHSURGXFWXVHGIRUFOHDQLQJWKHLQNVWDLQVRQWKHSORWWHUFDQ
LUULWDWHWKHVNLQDQGH\HV7KHXVHRIJORYHVZKHQKDQGOLQJWKLV
SURGXFWLVWKHUHIRUHUHFRPPHQGHG
To clean the ink stains, use the product supplied by Lectra Systèmes, ref. no.
900592. Spray the product on the stain to be removed and rub using
absorbent tissue or a soft cloth.
,ERHPMRK
Before handling the plotter:
- Check that the drain reservoir is not full. If it is full, replace it.
- Place the print head in the purge position (at the end of track to the right of
the plotter) and secure it in place using adhesive tape.
- If necessary, secure the ink supply cartridge using adhesive tape (this
should remain in place during transportation).