Lectra Alys 60 - Replacing the paper encoder tension bar; Adjustment of belt tension; Head drive belt tension

0IJXWMHISJ4PSXXIVWIIRJVSQXLIFEGO 
%% %P]WQEMRXIRERGIQERYEP
 %HNYWXQIRX
Adjust the height of the encoder feed roller as shown above. Tighten the 2
fastening screws for the paper feed encoder unit to a torque of 4 N.m.
 6ITPEGMRKXLITETIVIRGSHIVXIRWMSRFEV
!
$OZD\VVWDUWE\XQSOXJJLQJDOOWKHHOHFWULFDOFRQQHFWLRQVOLQNLQJWKH
SORWWHUWRWKHPDLQVDQGWRWKHFRQWUROOLQJ3&
Left side protection cover of the plotter removed
1. Remove the command electronics shielding cover.
2. Unplug the ribbon cable of the encoder to be replaced, from the main
electronics board.
0.5 to 0.7 mm
4ETIVXIRWMSRFEV
IRGSHIVWJSVYTTIVERH
PS[IVVSPPIVW