TE-QC & TE-Light Operating manual
8 LECUREUX SA
4 Special functions of the keys
These functions can be activated by simultaneously pressing and keeping pressed the darkened keys
immediately after powering on of the screwdriver. Release the keys only once the appropriate function has
been activated.
4.1 Announcement of the software-Version
☻ ☻
☺ ☺
4.2 Reset and default value
☺ ☻
☺ ☻
It is only possible with the jumper locking up.
4.3 Self check
☺ ☺
☻ ☻
Only success has with the insert test connectors
4.4 Setting the menu barrier (Protection)
☻ ☺
☻ ☺
Here the protection for a value movement can be set for each menu option. With Menu+ and menu one
moves by the menu options and with function + and function can the protection be switched on or off. With
switched on protection and taken off Jumper the appropriate function cannot be adjusted any longer.
Adjusting the menu barrier can take place only with put in Jumper.
4.5 Motor calibration
☺ ☻
☻ ☺
Menu + = correction of motor speed
Menu - = correction of motor torque
With the keys function +/- the appropriate correction can be adjusted from -30% to +30%. After completion of
the adjustments the appropriate values are stored when switching off the screwdriver.
Note that this correction cannot be used to increase the physical speed or torque limit of the
connected motor.
To Next Page
Loading...