7
CONFIGURING APP FOR BREECH LOCK BULLET SIZING KIT
Load
the feed
tube with
bullets
nose first.
Install shell
holder
adapter and
appropriate
sized
punch in
upper APP
casting.
The clear
bottle or an
empty powder
container can
be used to catch
sized bullets.
Product Dia. Product Dia. Product Dia.
91505 .224 91514 .314 91523 .427
91506 .225 91515 .323 91524 .429
91507 .243 91516 .329 91525 .430
91508 .278 91517 .339 91526 .451
91509 .284 91518 .356 91527 .452
91510 .285 91519 .357 91528 .454
91511 .308 91520 .358 91529 .457
91512 .309 91521 .401 91530 .501
91513 .311 91522 .410 91531 .510
Diameter not listed?
Custom service available factory-direct:
leeprecision.com/custom-breech-lock-bullet-sizer-punch
Breech Lock Bullet Sizer Kit
Product 91532
Install breech
lock bullet sizer
assembly in APP
base casting.
Tighten ⅓ of
a turn counter
clockwise.
Insert roll
marked end of
bullet sizer in
first into the
Breech Lock
insert.
Install aluminum
bottle adapter
into red bottle
adapter.
Roll mark in
first
Breech
Lock
insert
Bottle adapter
Install bottle adapter
on to bullet sizer
insert.
Sized bullets
will collect in
clear bottle.
You can also
use an empty
powder bottle
or any bottle
with a 53mm
or 43mm
thread.
Note:
If you applied too much Lee Liquid Alox® on your bullets,
you will have feeding problems as the bullets may stick to
the tube or fail to fall from the fingers. If this happens, dust
with powdered mica.
If powdered mica isn’t available, you can use powdered
graphite, but it’s messy.
Have a Bullet Sizing Kit and want to install on APP
press?
SEE INSTRUCTIONS HERE:
leeprecision.com/files/instruct/InstallBulletSizingKitIntoAPPpress.pdf
Bullet Sizer & Punch
To Next Page
Loading...
