8
Slide Bulge
Buster
punch into
shell holder
adapter.
Tighten
a ⅓ of
a turn
clockwise.
Assemble the Bulge Buster and Carbide Factory Crimp Die.
Punch
CONFIGURING APP FOR BULGE BUSTING
APP Bulge Buster Kit product # 91572 restores free function of rimless cases that have low base bulges. Low base bulges
usually occur from chambers that do not fully support the cartridge or cases resized in carbide dies from manufacturers other
than Lee. These show a noticeable stop ring near the base. You will most likely find cases with these problems in mixed range
brass.
Remove
crimp
sleeve and
adjusting
screw from
carbide
factory
crimp die.
Select appropriate intake
funnel and insert into
Breech Lock Bulge Buster
insert holder.
CARBIDE
FACTORY
CRIMP
CARTRIDGE INTAKE
FUNNEL
90867 380 ACP 380
90862 10mm, 40 S&W 10/40
90416 41 AE, 41 MAG 45
90864 45 ACP, 45 GAP, 45 WIN MAG 45
Intake funnel.
Roll mark in first.
Breech Lock Bulge Buster
intake funnel holder.
Please note: if you have
automation kit installed,
insure the jaws are
backed out (maximum
jaw opening).
See Riser & Jaw
adjustment page 4.
Spline drive lock
ring must be used
Install bulge
buster
assembly and
tighten ⅓ of
turn.
10
Insert cases into feed
tube (case mouth
down first) with case
inserter assembly
underneath.
Case mouth
down first
11
Push case through.
BUSTED!
Bulge busted cases
conveniently collect in
catch container, or use your
empty powder container
for even more capacity.
To Previous Page
Loading...
