6.2.3 MC1000 INPUTS AND OUTPUTS
The drive has two analog inputs (0-10 VDC and 4-20 mA) that can be used for speed reference, PID
setpoint reference, or PID feedback. A speed potentiometer (10,000 Ohm) can be used with the 0-10 VDC
input.
There are also two analog outputs: one is proportional to speed (frequency), and the other is proportional
to load.
The drive has three programmable outputs for status indication: one Form C relay and two open-collector
outputs.
Refer to Sections 14.0 - CONTROL WIRING and 15.0 - CONTROL WIRING DIAGRAMS for more
information.
16
To Next Page
Loading...
