13.0 KEYPAD CONTROL
The drive can be operated in a number of different ways: keypad (LOCAL), control devices wired to the
terminal strip (REMOTE), or a combination of the terminal strip and the keypad. The drive should first be
operated from the keypad during initial start-up. Refer to Sections 14.0 - CONTROL WIRING, and 18.0
- DESCRIPTION OF PARAMETERS for information on remote operation.
13.1 KEYPAD FUNCTIONS
START/STOP To start the drive, press the START key. To stop the drive, press the STOP
key.
NOTE: The STOP key is active in both LOCAL and REMOTE modes.
SPEED SETPOINT To increase the speed setpoint, press the UP arrow key. To decrease the
speed setpoint, press the DOWN arrow key.
FORWARD/REVERSE To change rotation direction, press the FWD/REV key and then press the
ENTER key within three seconds.
NOTE: Parameter 27 - ROTATION must be set to FWD & REV for this
key to be active.
AUTO/MANUAL To toggle between AUTOMATIC (terminal strip) and MANUAL (keypad)
speed control, press the AUTO/MAN key and then press the ENTER key
within three seconds.
NOTE: Parameter 28 - AUTO/MAN must be set to BOTH for this key to
be active. See Section 14.0 - CONTROL WIRING for information on
automatic speed references.
FAULT RESET Use the STOP key to reset a fault. If the fault condition has passed,
pressing the STOP key will reset the fault and return the drive to a STOP
condition.
NOTE: If an OUTPUT fault occurs, there will be a 30 second delay before
the fault can be cleared using the STOP key.
24
To Next Page
Loading...
Need help?
General
