2. Preparation / 2.1 Assemble and charge
Place the robot at Docking Station and make sure to align the
charging electrodes.
* Place the docking station on an open place.
* Connect the power supply and tidy up the power cord to
avoid twining.
Turn on the robot
Placement of the charging base / connection of power supply
Reminder: Cannot charge when the robot is turned off.
Charging
Remove the protective film on the robot and docking station
Install the side brushes
“ I ”means ON , “ O ”means OFF
twinkling means charging.
turn off means fully charged.
A full charge takes 5 hours.
Tidy up the room
If the rug at home has fringed
edges, please put the edges
under the rug in advance.
Organize the items on the floor,
such as wires, slippers and other
sundries to avoid affecting the
operation of the robot
The robot can climb to the top of
objects with a height of less than
12mm. If you don't want the robot
to climb on them, please take
them away.
Do not let the robot operate on
wet floors.
2. Preparation /
2.2 Using environment preparation
Click
>0.5m
(1.64’)
>0.5m
(1.64’)
>1.5m
(4.92’)
To Next Page
Loading...
