After measuring the left channel, Recording successful will display at the bottom of the screen. If you see an error such as “Volume
too low,” please check the connections and/or increase the level and measure the left channel again. A successful left channel
measurement will display “Recording successful.” at the bottom of the screen, as shown above.
Repeat the process for your right speaker. Finally, click Upload to server- this sends the measurements to the room correction server
which calculates the ideal settings for your speakers and automatically sends them back to your Wavelet.
After a few minutes, you can observe progress by clicking Check server progress at the bottom of the screen. This process may take 5
- 10 minutes. You will be prompted when the process is complete.
Room Correction can now be toggled off and on, during playback, from the Wavelet Dashboard.
To Next Page
Loading...