13 HOMEDEPOT.CA
Please contact 1-877-527-0313 for further assistance.
Operation (continued)
Switch box
Extension cord
STARTING AND STOPPING
WARNING: Before switching on the electric scarifier +
dethatcher, make sure that it is not in contact with any
foreign objects. Keep your feet and hands a safe distance
away from the rotating tines and the ejector opening.
Failure to comply with these warnings can result in severe
personal injury.
1. To start, press and hold the safety lock button while pulling the
switch lever toward you. Once the machine powers on, release
the safety lock button and proceed with operation (Fig. 3).
Switch lever
Safety lock button
Fig. 3
2. To stop the electric scarifier + dethatcher, release the switch
lever.
WARNING: The tine cylinder continues to run for a brief
period after the unit has been switched off. Do not tilt or
carry the unit while the motor is still running and do not
touch the cylinder while it is still rotating. Failure to comply
could result in severe personal injury.
OVERLOAD PROTECTION
The overload protection will be activated in the following
circumstances:
1. A build up of scarified material around the cutting device.
2. If the material scarified is larger than the motor capacity.
3. Where there is too much resistance against the cutting
device.
When the circuit breaker has been activated switch off the product
and disconnect from the power supply.
Let the product cool down and eliminate the cause before using the
product again.
GENERAL OPERATION
WARNING: If the product strikes a foreign object stop the
motor. Switch the product off, disconnect it from the power
supply and let it cool down. Inspect the product thoroughly
for damage. Have any damage repaired before restarting.
WARNING: Extensive vibration of the product during
operation is an indication of damage. The product should be
promptly inspected and repaired.
□ Check the machine, its power cord and plug as well as
accessories for damage before each use. Do not use the
machine if it is damaged or shows wear.
□ Double check that accessories are properly fixed.
□ Push the machine forward by its handle. Keep the handle dry to
ensure safe support.
□ Ensure that the air vents are always unobstructed and clear.
Clean them if necessary with a soft brush. Blocked air vents
may lead to overheating and damage the product.
□ Switch the machine off immediately if you are disturbed while
working by other people entering the working area. Always let
the machine come to complete stop before putting it down.
□ Do not overwork yourself. Take regular breaks to ensure you
can concentrate on the work and have full control over the
machine.
□ Mow the lawn before working and fertilize afterwards.
□ Make sure that the lawn is clear of stones, sticks, wire, or other
objects that could damage the machine or its motor.
□ Select the suitable cutting depth for the actual grass height.
To Next Page
Loading...