16
Maintenance (continued)
WARNING: Make sure the cutting device (dethatcher
cylinder) is inserted properly. Make sure the semi-circle
on the bearing seat of the cylinder goes downward into
the unit. If the semi-circle is face up, it has been inserted
incorrectly (Fig. 8).
Semi-circle
NOTE: If you have any questions, please call the customer
service center at 1-877-527-0313 for assistance.
AFTER USE
1. Switch the machine off, disconnect it from the power supply
and let it cool down.
2. Check, clean and store the machine as described below.
Cleaning and Storage
1. Clean the exterior of the machine thoroughly using a soft brush
and cloth before storing. Do not use water, solvents, or polishes.
2. Turn the electric scarifier + dethatcher on its side to clean the
cylinder area.
NOTE: Due to heavy use or when the grass is wet,
clippings tend to stick to and accumulate around the
cylinder, which will cause overheating. To prevent this, clean
the cylinder of all the grass clippings after every use.
3. Store the electric scarifier + dethatcher in a dry place. Do not
place other objects on top of the electric scarifier + dethatcher
during storage.
THATCH COLLECTION BAG
1. Inspect the thatch collection bag before each use. Do not use it
if you find any damage.
2. Clean the thatch collection bag after operation. Let the thatch
collection bag dry thoroughly before storing to avoid mildew.
TRANSPORTATION
1. Switch the product off and disconnect it from power supply
before transporting it anywhere.
2. Attach transportation guards, if applicable.
3. Adjust the cutting depth to the transportation stage (refer to
“CUTTING DEPTH ADJUSTMENT” on page 12).
4. Always transport the product by its handle.
5. Protect the product from any heavy impact or strong vibrations
which may occur during transportation in vehicles.
6. Secure the product to prevent it from slipping or falling over.
To Next Page
Loading...