11
System Connections
Connecting to a PC
The unit can be connected to a PC via the VGA cable and PC audio cable.
1. Connect one end of the VGA cable to the VGA jack on the jack panel of the unit and the other
end to the PC VGA output.
2. Connect one end of the audio cables to the PC IN jack on the jack panel of the unit and the
other end to the PC audio output jack.
3. Set the PC video resolution to match that of the television (Native 1920 x 1080@60Hz).
4. After connection, turn on the power of the unit and the PC.
5. Press INPUT then direction buttons to select PC mode, and then press the ENTER button to
confirm.
Connecting to TV-Signal Input
Connect the TV signal cable (the antenna cable, for
example) to the RF input Jack on the back of the unit
so that you can receive television programs.
1. Connect TV signal input source from the aerial
to the RF input jack on the rear panel of the unit.
2. After connection, turn on the power of the unit.
3. Then press the INPUT button and the direction
buttons to select TV mode, press the ENTER
button to confirm and conduct program
selection.
To Next Page
Loading...
Need help?
General
