FRONT PANEL DESCRIPTION
1 Power LED
On: Power is applied to the device.
Off: No power is applied to the device.
2 HDMI LED
On: HDMI input signal is active.
Off: No HDMI signal input.
3 Link LED
On: HDBT link is normal.
Off/Blinking: No HDBT link or link error.
4 HDMI IN Connect to an HDMI source using an HDMI cable.
5 USB Host Connect USB host PC.
REAR PANEL DESCRIPTION
6 HDBT OUT Connect to the HDBT receiver via a Cat 5e/6/6a/7 cable.
7 DC 12V
Connect to a DC 12V power adapter. With one-way PoH
function supported, the transmitter can be powered by the
receiver.
8 RS232
Connect to a RS232 enabled device for RS232 pass-through or
connect to a PC for upgrading firmware.
9
RS232
DIP Switch
Set the function of RS232 port.
Pass-through: The RS232 port is used to commands pass-
through via HDBT. Users can use API command to upgrade its
MCU firmware in this mode.
Update: The RS232 port is used to upgrade Valens firmware of
transmitter and receiver.
Transmier
Transmier
-
-
To Next Page
Loading...