Receiver
Receiver
FRONT PANEL DESCRIPTION
1 Power LED
On: Power is applied to the device.
Off: No power is applied to the device.
2 Status LED
Blinking: The device is working properly.
Off: The device is not working properly.
3 HDCP LED
On: HDCP protected content is being transmitted.
Blinking: Non-HDCP protected content is being transmitted.
Off: No content is being transmitted.
4 Link LED
On: HDBT link is normal.
Off/Blinking: No HDBT link or link error.
5
RS232
DIP Switch
Set the function of RS232 port.
Pass-through: RS232 port is used to RS232 command pass-
through over HDBT.
Update: RS232 port is used to upgrade Valens firmware.
REAR PANEL DESCRIPTION
6
DC 12V
Connect to the power adapter provided. With one-Way PoH
function supported, one power adapter is needed to connect
to the receiver to power both units.
7
HDBT IN Connect to the transmitter via a Cat 5e/6/6a/7 cable.
8
RS232
Connect to a RS232 enabled device for RS232 pass-through
or firmware upgrade.
9
HDMI OUT Connect to an HDMI display device.
10
USB Device
Connect to USB devices (e.g. keyboard, mouse, USB
camera, USB flash drive, etc.).
Note: USB ports support the USB 2.0 standard with a
maximum of 5V/500mA. Before connecting a USB 3.0
device, confirm its compatibility with USB 2.0.
-
-
To Next Page
Loading...