LEGRAND C2G - Features; Package Contents; Mounting Bracket Installation


• HDMI 2.0 with 4K@60Hz 4:4:4 8bit and HDCP 2.2 compability
• Supports signal transmission up to 35m/115 for 4K and 60m/197 for 1080P via a
single Cat 5e/6 cable
• Supports signal transmission up to 40m/131 for 4K and 70m/230 for 1080P via a
single Cat 6a/7 cable
• Supports one-way PoH, the transmier can be powered by the receiver
• Supports USB pass-through and RS232 pass- through via HDBT port
• Supports rmware upgrade through RS232 port, and can be set through the DIP switch

Note: Before installaon, please ensure the unit is disconnected from the power
source.
1. Aach the installaon bracket to the enclosure using the screws that were
provided in the package separately.
2. The bracket is aached to the enclosure as shown.
3. Repeat steps 1-2 for the other side of the unit.
4. Aach the brackets to the surface you want to mount to using screws (not
included).


• 1 x Transmier
• 1 x Receiver
• 1 x DC 12V Adapter with US, UK, EU
and AU Cables
• 1 x Phoenix Connector (3.5mm, 2 Pins)
• 2 x Phoenix Connector (3.5mm, 3 Pins)
• 1 x 1 – Gang US Socket Cover, White
(with Screws)
• 2 x Mounng Bracket (with screws)
• 1 x Manual

-
-