LEGRAND C2G - Wiring


Warnings:
• Before wiring, disconnect the power from all devices.
• During wiring, connect and disconnect the cables gently.
Steps for device wiring:
1. Connect an HDMI source to the HDMI IN port of the
transmier.
2. Connect an HDMI display to HDMI OUT port of the receiver.
3. Connect HDBT OUT port of the transmier to HDBT IN port of
the receiver via a single Cat 5e/6/6a/7 cable.
4. Connect addional funcons opons.
• USB pass-through: Connect USB host PC to HOST port of
the transmier, and connect USB devices such as keyboard
and mouse to USB DEVICE ports of the receiver. The
connected USB devices can be connected to the host PC.
• RS232 pass-through: Set the DIP switch to PASS-THROUGH
posion, connect a RS232 enable device such as a PC to
RS232 port of the transmier and receiver respecvely.
5. Connect the provided DC 12V power adapter to the receiver.
Note: With one-way PoH funcon supported, the transmier can
be powered by the receiver, no addional power adapter is
needed to be connected to the transmier.
6. Power on all aached devices.


-
-