18
EN
PREMIUS
1-10 kVA
3.5.1.4. Connect the utility separately to the terminal blocks of the UPS’ Utility and Bypass inputs. Switch on the
power breaker of the distribution panel and the breakers of the UPS’ Utility and Bypass inputs. Green LEDs
and show that the Utility and Bypass inputs are normal. UPS with parallel function enabled will
display first figure A1, then figure A2, and then figure B. Otherwise the LCD will display figure A1 directly
followed by figure B.
A1.
A2.
B.
3.5.1.5. The UPS is in Bypass Mode now. It will proceed to self-test automatically. If no abnormal message appears
then the pre-startup of the UPS was successful and the charger starts to charge the batteries.
3.5.1.6. Press the UPS On Switch for approximately three seconds. The Buzzer sounds twice and the LCD
display changes from figure B to figure C.
C.
3.5.1.7. The UPS is in self-test mode again. The LCD display will change from figure C to figure D, and the UPS
will remain in battery mode for approximately four seconds. Then the display will change from figure E1 to
figure F if the self-test was successful.
INPUT LOAD
Foult
Low
Testing
UPS
KVA
WHz
Mine
%
0
C
88.8
Parallal ID Mode
Bypass Stop
Utility Invertar
Voltage Adjust
Frequency Window
Buzzer Code
Battery Autonomy
Overload
Service
Bypass
Utility
?
Wiring Fault
Alarm
!
INPUTLOAD
UPS
INPUTLOAD
UPS
Utility
V
To Next Page
Loading...
