LEGRAND PREMIUS - Startup in Battery Mode (Cold Start)

19
D
“test”
E1
“OK” in self-test
E2
“Fail” in self-test
F
220 VAC’ in Utility Input
3.5.1.8. If the self-test fails the LCD display will change from figure D to figure E2. Then an error code or error
status will appear on the screen.
3.5.1.9. Startup operation of the UPS is complete now. Make sure the UPS is plugged into the wall receptacle for
charging at least 8 hours and the batteries are fully charged before connecting the device to be protected.
3.5.2 Startup in Battery Mode (Cold Start)
3.5.2.1. Make sure the UPS has at least one set of batteries
3.5.2.2. Push the UPS on Switch once for approximately 5 seconds to awaken the UPS. The buzzer will sound
twice. The LCD display will change from figure A to figure G for approximately 15 seconds.
3.5.2.3. Press the UPS On Switch again for about three seconds until the LCD display changes from figure G
to figure H. Then the UPS will be in self-test mode. The UPS may offer energy to the output in a minute,
and the LCD displays figure I. In case of failure in pushing the UPS On Switch for 15 seconds, the UPS will
automatically turn off. You must then repeat steps 3.4.2.1 to 3.4.2.3.
Testing
INPUTLOAD
UPS
Testing
INPUTLOAD
UPS
Testing
INPUTLOAD
UPS
INPUTLOAD
UPS
Utility
V