Malfunctions and resolving them
1. The Digital-Modul-R does not respond when
switched on.
1.1
Is the battery inserted correctly or is the charger
connected correctly?
The battery is only charged outside the Digital-
Modul-R.
1.2
Does the battery have sufficient charge?
Use a charged battery.
2. The Digital-Modul-R switches off again
immediately after being switched on.
2.1
Does the battery have sufficient charge to operate
the Digital-Modul-R?
Charge the battery or insert a charged battery.
2.2
Is there any condensation?
This occurs if the Digital-Modul-R is moved from
a cold place to a warm one. Wait until the con-
densation clears.
3.
I cannot save the picture.
3.1
Is a memory card inserted?
3.2
The capacity of the memory card is full.
Delete pictures you no longer require before
taking new ones.
4. The monitor is too dark or too bright.
4.1
Set the desired brightness.
5. The picture I have just taken is not shown in
the monitor
5.1
Is the
Auto Review
function activated (when the
Digital-Modul-R is set to recording mode)?
6. I cannot display the picture.
6.1
Is a memory card inserted?
6.2
The memory card does not contain any data.
7.
Despite being connected to a computer,
I cannot transfer any data.
7.1
Check that the computer and the Digital-Modul-R
are correctly connected to one another.
8.
The time and date information is incorrect.
8.1
The Digital-Modul-R has not been used for a long
time, particularly if the battery has been removed.
Set the date and time.
Warning messages / Malfunctions / 111
To Next Page
Loading...
Need help?
General
