Leica DISTO E7300 - Operations; Switching ON;OFF; Measuring Reference

Leica DISTO
TM
E7300 788218a
3
ENOperations
Switching ON/OFF Clear Message Codes
ON
OFF
2 sec
Device is turned
OFF.
i
Press ON button
2 sec to start
continuous laser
mode.
1x
Undo last action.
2x
Leave actual func-
tion, go to default
operation mode.
If the message "InFo" appears with a
number, observe the instructions in
"Message Codes" section.
Example:
Adjusting measuring reference
Distance is measured from the
front of the device.
1
i
Press button
2sec and ref-
erence from
front is set
permanently.
Distance is measured from the rear of
the device (standard setting).
2
Multifunctional endpiece Unit setting
i
The orientation
of the endpiece
is automatically
detected and
the zero point is
adjusted
accordingly.
2 sec
simultane-
ously
Switch between the
following units:
0.000 m
0.0000 m
0.00 m
0.00 ft
0‘00‘‘ 1/32
0‘00‘‘ 1/16
0‘00‘‘ 1/8
0‘00‘‘ 1/4
0.00 in
0 in 1/32
0 in 1/16
0 in 1/8
0 in 1/4
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com